Pursuing the principle of "Customer First, Integrity First", wire mesh supplier are sincerely expecting to cooperate with you!

Wood Fence Posts

by:Bluekin     2020-07-17

Plan to set a minimum of one-fourth to at least one-third of the fence publish underground, and dig the hole accordingly. Once you set the next post, you'll must measure to ensure the identical length of post is above floor for all posts. of gravel around the fence publish and then prime with concrete.

If the concrete is just too loose, use braces to keep the post upright. Check that the publish is flush with the string line and plumb. It's finest to let the concrete treatment for 3 or four days before attaching fence rails, fence panels, or chain link. Make sure the concrete is tough earlier than attaching anything that places weight on the posts.

The length between posts is dependent upon the kind of fencing material you're using. If you are using preset panels, take that into consideration when marking for the holes. One of my favourite aspects of a metal fence with multiple excessive-high quality coatings is that the posts don’t rot within the floor.

Before digging the holes for concrete or gravel footing, set the road. Put stakes in the ground where the nook posts will go.

Run a taut string between the two stakes for both sides of the fence. Use a measuring tape to measure common intervals the place the fence posts will go.
Custom message
Contact